![]() Continue placing further signal harness objects or right-click or press Esc to exit placement mode.After placing the final vertex point, right-click or press Esc to complete placement of the signal harness.Position the cursor then click or press Enter to anchor a series of vertex points that define the shape of the signal harness.Click or press Enter to anchor the starting point for the signal harness.Placement is made by performing the following sequence of actions: ![]() Click the button on the Wiring toolbar.Īfter launching the command, the cursor will change to a cross-hair and you will enter signal harness placement mode.Right-click in the design space then choose Place » Harness » Signal Harness from the context menu.Once a command has been used, it will become the top-most item on that section of the Active Bar.) (Click and hold an Active Bar button to access other related commands. Click the Signal Harness button ( ) in the graphic objects drop-down on the Active Bar located at the top of the design space.Choose Place » Harness » Signal Harness from the main menus.Signal harnesses are available for placement in the Schematic Editor in one of the following ways: They allow for a more complex design within the same schematic design space, which increases the readability of designs and builds potential for reuse. Signal Harnesses allow for the creation and manipulation of higher level abstract connections between sub-circuits in your PCB Projects. It is an abstract connection that enables the logical grouping of different signals including buses, wires and other signal harnesses for increased flexibility and streamlined design. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |